See an example below, where the board IP and MAC addresses, found by scanning the LAN from the interface enp3s0f1 on your PC, are 192.168.10.43 and 00:14:2d:63:19:3f respectively: See from the example below, that the wired interface is enp3s0f1 and the Wi-Fi is wlo1:Īfter you have identified one interface connected to the same network as your board, use arp-scan to find the board IP address: # sudo arp-scan -localnet -interface= Warning: Make sure that both your board and your PC are connected to the same LAN.Ī relatively big list might be displayed, depending on how many physical and virtual active interfaces you have. Install Nmap from the Nmap Official Website (Windows host only).įirst, use the ip command to list the network interfaces available and active on your computer: $ ip link show up.This article will show how you can scan your local network in order to find the IP address of your board. During the development of your embedded project, you might need a remote connection to the board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |